ASTM D3359-09 标准试验方法 胶带法测量附着力

ASTM D3359-09 标准试验方法 胶带法测量附着力

Designation: D 3359 – 02

名称: D 3359-02

Standard Test Methods for

Measuring Adhesion by Tape Test1

ASTM D3359-09 标准试验方法胶带法测量附着力

This standard is issued under the fixed designation D 3359; the number immediately

following the designation indicates the year of original adoption or, in the case of revision, the year of last revision. A number in parentheses indicates the year of last reapproval. A superscript epsilon (e) indicates an editorial change since the last revision or reapproval.

这个标准是D 3359确定了以后发行的。数字代表名称最初通过的时间,或者修订情况,和最新版本。括号内的数字代表最新重新审批时间。上标代表最新版本的变化或重新审批。

This standard has been approved for use by agencies of the Department of Defense.


1. Scope 范围

1.1 These test methods cover procedures for assessing the adhesion of coating films to metallic substrates by applying and removing pressure-sensitive tape over cuts made in the film.


1.2 Test Method A is primarily intended for use at job sites while Test Method B is more suitable for use in the laboratory. Also, Test Method B is not considered suitable for

films thicker than 5 mils (125µm).

试验方法A主要是供工作场所用,而试验方法B更适合实验室使用。试验方法B被视为不适合厚度超过 5毫英寸(125微米)的漆膜。

NOTE 1—Subject to agreement between the purchaser and the seller,Test Method B can be used for thicker films if wider spaced cuts are employed.

注 1-根据买卖双方的协议,如果切割间距较宽,漆膜较厚时可采用试验方法B。

1.3 These test methods are used to establish whether the adhesion of a coating to a

第1页/共23页 下一页>尾页